159
Parameters
server-name: Specifies a portal authentication server by its name, a case-sensitive string of 1 to 32
characters.
Usage guidelines
If you do not specify the server-name argument, this command displays information about all portal
authentication servers.
Examples
# Display information about portal authentication server pts.
<Sysname> display portal server pts
Portal server: pts
IP : 192.168.0.111
VPN instance : vpn1
Port : 50100
Server detection : Timeout 60s Action: log, trap
User synchronization : Timeout 200s
Status : Up
Table 17 Command output
Field Descri
tion
Portal server Name of the portal authentication server.
IP IP address of the portal authentication server.
VPN instance MPLS L3VPN where the portal authentication server resides.
Port Listening port on the portal authentication server.
Server detection
Parameters for portal authentication server detection:
• Detection timeout in seconds.
• Actions (log and trap) triggered by the reachability status change of the portal
authentication server.
User synchronization User idle timeout in seconds for portal user synchronization.
Status
Reachability status of the portal authentication server:
• N/A—Portal authentication server detection is disabled. Reachability status of
the server is unknown.
• Up—Portal authentication server detection is enabled. The server is reachable.
• Down—Portal authentication server detection is enabled. The server is
unreachable.
Related commands
• portal enable
• portal server
• server-detect (portal authentication server view)
• user-sync