444
Syntax
application statistics enable [ inbound | outbound ]
undo application statistics enable [ inbound | outbound ]
Default
The application statistics function is disabled on an interface.
Views
Layer 3 interface view
Predefined user roles
network-admin
Parameters
inbound: Specifies the inbound direction of the interface.
outbound: Specifies the outbound direction of the interface.
Usage guidelines
IMPORTANT:
The application statistics function consumes a large amount of system memory. When the system
generates a low-memory alarm, disable the application statistics function on interfaces.
If no direction is specified, application statistics is enabled in both the inbound and outbound directions.
When this function is enabled, the device separately counts the number of packets or bytes that the
interface has received or sent for each application protocol. It also calculates the transmission rates of the
interface for these protocols.
To display application statistics, use the display application statistics command.
Examples
# Enable application statistics in the inbound direction of interface GigabitEthernet 2/1/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 2/1/1
[Sysname-GigabitEthernet2/1/1] application statistics enable inbound
# Enable application statistics in the outbound direction of interface GigabitEthernet 2/1/2.
<Sysname> system-view
[Sysname] interface gigabitethernet 2/1/2
[Sysname-GigabitEthernet2/1/2] application statistics enable outbound
# Enable application statistics in the inbound and outbound directions of interface GigabitEthernet
2/1/3.
<Sysname> system-view
[Sysname] interface gigabitethernet 2/1/3
[Sysname-GigabitEthernet2/1/3] application statistics enable
Related commands
display application statistics
To Next Page
Loading...
Need help?
General
