471
destination-ip destination-ip: Specifies a destination IP address. The destination-ip argument specifies
the destination IP address of a session from the initiator to the responder.
verbose: Displays detailed information about session entries. If you do not specify this keyword, this
command displays brief information about session entries.
Usage guidelines
If no parameter except IPv4 or IPv6 is specified, this command displays all IPv4 or IPv6 session entries.
Examples
# (MSR1000/MSR2000/MSR3000.) Display brief information about all IPv4 session entries.
<Sysname> display session table ipv4
Initiator:
Source IP/port: 192.168.1.18/1877
Destination IP/port: 192.168.1.55/22
DS-Lite tunnel peer: -
VPN instance/VLAN ID/VLL ID: -/-/-
Protocol: TCP(6)
Initiator:
Source IP/port: 192.168.1.18/1792
Destination IP/port: 192.168.1.55/2048
DS-Lite tunnel peer: -
VPN instance/VLAN ID/VLL ID: -/-/-
Protocol: ICMP(1)
Total sessions found: 2
# (MSR4000.) Display brief information about all IPv4 session entries.
<Sysname> display session table ipv4
Slot 1:
Initiator:
Source IP/port: 192.168.1.18/1877
Destination IP/port: 192.168.1.55/22
DS-Lite tunnel peer: -
VPN instance/VLAN ID/VLL ID: -/-/-
Protocol: TCP(6)
Initiator:
Source IP/port: 192.168.1.18/1792
Destination IP/port: 192.168.1.55/2048
DS-Lite tunnel peer: -
VPN instance/VLAN ID/VLL ID: -/-/-
Protocol: ICMP(1)
Total sessions found: 2
# (MSR1000/MSR2000/MSR3000.) Display detailed information about all IPv4 session entries.
<Sysname> display session table ipv4 verbose
Initiator:
Source IP/port: 192.168.1.18/1877
To Next Page
Loading...
Need help?
General
