492
3 Src 100 90 3020
200 -- 100000 89000 2005
# Display information about the IPv6 connection limit policy 3.
<Sysname> display connection-limit ipv6-policy 3
IPv6 connection limit policy 3 has been applied 3 times, and has 2 limit rules.
Limit rule list:
Policy Rule Stat Type HiThres LoThres ACL
--------------------------------------------------------------------------------
3 1 Src-Dst 1000 800 3010
2 Dst 500 450 3001
Application list:
GigabitEthernet2/1/1
Vlan-interface1
Tunnel0
Table 68 Command output
Field Descri
tion
Limit rule list Connection limit policy information.
Policy Number of the connection limit policy.
Rule Number of the connection limit rule.
Stat Type
Statistics types:
• Src-Dst-Port—Limits connections by source IP service, destination IP, and
service combination.
• Src-Dst—Limits connections by source IP address and destination IP address
combination.
• Src-Port—Limits connections by source IP and service combination.
• Dst-Port—Limits connections by destination IP and service combination.
• Src—Limits connections by source IP address.
• Dst—Limits connections by destination IP address.
• Port—Limits connections by service.
• --—Limits connections not by a specific IP address or service. All
connections that match the ACL referenced by the rule are limited.
HiThres Upper limit of the connections.
LoThres Lower limit of the connections.
ACL Number or name of the ACL referenced by the rule.
Application list
Application list of the connection limit policy, including interface name and
Global. Global indicates that the connection limit policy is applied globally.
Related commands
• connection-limit
• connection-limit apply
• connection-limit apply global
• limit