HP MSR SERIES

659
undo udp-flood threshold
Default
The global threshold is 1000 for triggering UDP flood attack prevention.
Views
Attack defense policy view
Predefined user roles
network-admin
Parameters
threshold-value: Specifies the threshold for triggering UDP flood attack prevention. The value range is 1
to 64000 in units of UDP packets sent to an IP address per second.
Usage guidelines
The global threshold applies to UDP flood attack detection for non-specific IP addresses.
Adjust the threshold according to the application scenarios. If the number of UDP packets to a protected
server, such as an HTTP or FTP server, is normally large, set a large threshold. A small threshold might
affect the server services. For a network that is unstable or susceptible to attacks, set a small threshold.
Examples
# Set the global threshold to 100 for triggering UDP flood attack prevention in attack defense policy
atk-policy-1.
<Sysname> system-view
[Sysname] attack-defense policy atk-policy-1
[Sysname-attack-defense-policy-atk-policy-1] rst-flood threshold 100
Related commands
• udp-flood action
• udp-flood detect
• udp-flood detect non-specific