HTA HT2000H - Page 91

HT2000H_en_n.doc Page 95 of 167
Injection Synchro
The autosampler
starts sample
preparation
The autosampler
injects the sample
in the injector
The autosampler
gives the “Start”
signal to the an-
alyzer
A-Start
At the reception of the
“Ready” signal from
the analyzer
After ending the
sample preparation
the autosampler
checks again for the
presence of the
“Ready” signal from
the analyzer and then
starts the injection
When the autosampler
touches the injector
D-Start
At the reception of the
“Ready” signal from
the analyzer
After ending the
sample preparation
the autosampler
checks again for the
presence of the
“Ready” signal from
the analyzer and then
starts the injection
At the end of the
syringe plunger
movement
EA
As Normal
Normal w/o Rdy
At the end of the anal-
ysis time set in the au-
tosampler method
(see paragraph
5.2.2.1)
After the ending
sample preparation
At the beginning of the
syringe plunger
movement
DIN
(to be set for special
application only)
At the reception of the
“Ready” signal from
the analyzer
No injection is carried
out
At the beginning of the
syringe plunger
movement, when
needle has reached
the proper depth in-
side the vial
• Shaker speed. It sets the speed of the shaking.
• Maintenance Warnings. It sets when the Maintenance Warning messages (see paragraph
4.2.4.5 “Setup configuration: Maintenance”) can be displayed.