Step 4 Remove the shell of the new door status sensor and remove the screws from the
signal cables.
Step 5 Properly place a new door sensor at the installation position and tighten the
screws.
Step 6 Place the alarm cables in sequence and secure the screws.
Step 7 Reinstall the shell of the door status sensor.
----End
Follow-up Procedure
Check that the door status alarm is cleared.
4.3.27 Replacing a Light
Prerequisites
● You have obtained the cabinet door key, and phillips screwdriver.
● The new light is intact.
Procedure
Step 1 Remove the damaged light.
Figure 4-49 Removing the light
Step 2 Install a new light.
iSitePower Integrated Smart Site (ICC1000-A1-E1)
User Manual 4 Maintenance
Issue 04 (2022-10-15) Copyright © Huawei Technologies Co., Ltd. 154
To Next Page
Loading...
