Hypertherm Powermax45 XP User Manual

Powermax45 XP Operator Manual 809240 121
Cut Charts and Marking Charts
WARNING
EXPLOSION HAZARD – CUTTING WITH ALUMINUM NEAR WATER
Do not cut aluminum alloys underwater or on a water table unless you can prevent
the accumulation of hydrogen gas. Never cut aluminum-lithium alloys in the
presence of water.
Aluminum can react with water to produce hydrogen, resulting in a potentially
explosive condition that can detonate during plasma cutting operations. Refer to the
Safety and Compliance Manual (80669C) for more information.
WARNING
EXPLOSION HAZARD – CUTTING WITH FUEL GASES
Do not use combustible fuel gases or oxidizing gases with Powermax systems.
These gases can result in explosive conditions during plasma cutting operations.
WARNING
TOXIC FUMES CAN CAUSE INJURY OR DEATH
Some metals, including stainless steel, may release toxic fumes when cut. Make sure
your work site has adequate ventilation to ensure that the air quality level meets all
local and national standards and regulations. Refer to the Safety and Compliance
Manual (80669C) for more information.
ARC WELDING SUPPLIES - 07 847 7870

Hypertherm Powermax45 XP Specifications

General

Output Current	10-45 A
Gas Supply	Clean, dry, oil-free air or nitrogen
Torch Style	Handheld or mechanized
Input Voltage	50/60 Hz
Cutting Thickness	12 mm (1/2")
Cutting Capacity	16 mm (5/8 in)
Recommended Gas Inlet Flow Rate/Pressure	6.2 bar