Hypertherm Powermax45 XP - Finecut Consumables; Hyaccess Cutting Consumables; Shielded Drag-Cutting Consumables; Specialty Consumables

Cut with the Hand Torch
3
62 809240 Operator Manual Powermax45 XP
Shielded drag-cutting consumables
FineCut consumables
Specialty consumables
HyAccess cutting consumables
HyAccess consumables extend the reach of the regular shielded consumables by approximately
7.5 cm (3 inches). Use them with your hand torch to achieve greater reach and visibility.

HyAccess gouging consumables are also available. See page 73.
You can expect to cut approximately the same thicknesses as with the regular shielded
consumables. You may need to reduce your cut speed slightly to achieve the same cut quality.
Typically, you can expect HyAccess consumables to last approximately half as long as the regular
shielded consumables.
220818
Shield
220854
Retaining cap
220941
Nozzle
220857
Swirl ring
220842
Electrode
220931
Deflector
220854
Retaining cap
220930
Nozzle
220947
Swirl ring
220842
Electrode
420410
Cutting nozzle
420408
Electrode
220857
Swirl ring
420413
Retaining cap
ARC WELDING SUPPLIES - 07 847 7870