Hypertherm Powermax45 XP - Prepare the power cord

Installation and Setup
1
32 809240 Operator Manual Powermax45 XP
Prepare the power cord
CSA systems
1-phase (200 V – 240 V)
 10 AWG 3-wire power cord
 50 A, 250 V power plug
(NEMA 6-50P) included
3-phase (480 V)
 14 AWG 4-wire power cord
 Power plug not included*
* An appropriate plug must be installed on the power cord by a licensed electrician according to national and
local codes.
CE/CCC systems
1-phase (200 V – 240 V)
 6mm
2
3-wire H07RN-F power cord
 Power plug not included*
3-phase (380 V / 400 V)
 2.5 mm
2
4-wire H07RN-F power cord
 Power plug not included*
* An appropriate plug must be installed on the power cord by a licensed electrician according to national and
local codes.
NEMA 6-50P (1-phase)
ARC WELDING SUPPLIES - 07 847 7870