Hypertherm Powermax45 XP - Reset the Gas Pressure

Operation
2
56 809240 Operator Manual Powermax45 XP
Reset the gas pressure
When you manually adjust the gas pressure, the pressure you set remains in place until you reset it.
You can reset the gas pressure by pressing the Mode button.

When you reset the gas pressure, the selected mode LED stops blinking.
The gas pressure also resets to the default setting when:
 You are in gouge/marking mode and you change the output current from:
 The Maximum Control gouging process (26 – 45 A) to the Precision gouging process
(10 – 25 A)
 The Precision gouging process (10 – 25 A) to the Maximum Control gouging process
(26 – 45 A)
 You connect a different torch to the power supply.

Turning the power supply OFF and ON does not reset the gas pressure.
Press the button to reset the gas pressure.
ARC WELDING SUPPLIES - 07 847 7870