Hypertherm Powermax45 XP - Gouge with the machine torch

Gouge with the Hand Torch and Machine Torch
4
80 809240 Operator Manual Powermax45 XP
Gouge with the machine torch
You can vary the gouge profile by adjusting the:
 Output current (amperage) of the power supply
 Angle of the torch to the workpiece
 Rotation of the torch relative to the torch center line
 Torch-to-work st andoff
 Speed of the torch over the workpiece
See page 74 for more details.
Standoff
Angle
Rotation of torch (relative
to torch center line)
Torch center line
Speed
ARC WELDING SUPPLIES - 07 847 7870