Hypertherm Powermax45 XP - Page 69

Cut with the Hand Torch
3
Powermax45 XP Operator Manual 809240 69
3. Straight pierce: Press the torch trigger to start the arc.
Rolling pierce: Press the torch trigger to start the arc while still at an angle to the workpiece,
then rotate the torch to the perpendicular (90°) position.
4. Hold the torch in place while continuing to press the trigger. When sparks exit below the
workpiece, the arc has pierced the material.
5. When the pierce is complete, drag the torch tip lightly along the workpiece to proceed with the
cut.
ARC WELDING SUPPLIES - 07 847 7870