Hypertherm Powermax45 XP User Manual

809240 Operator Manual Powermax45 XP 7
Contents
Electromagnetic Compatibility (EMC) ............................................................................ SC-15
Introduction....................................................................................................................................................SC-15
Installation and use ......................................................................................................................................SC-15
Assessment of area .....................................................................................................................................SC-15
Methods of reducing emissions................................................................................................................SC-15
Mains supply......................................................................................................................................SC-15
Maintenance of cutting equipment...........................................................................................................SC-15
Cutting cables...............................................................................................................................................SC-15
Equipotential bonding .....................................................................................................................SC-15
Earthing of the workpiece ..............................................................................................................SC-16
Screening and shielding.............................................................................................................................SC-16
Warranty............................................................................................................................... SC-17
Attention.........................................................................................................................................................SC-17
General...........................................................................................................................................................SC-17
Patent indemnity...........................................................................................................................................SC-17
Limitation of liability......................................................................................................................................SC-17
National and local codes............................................................................................................................SC-17
Liability cap....................................................................................................................................................SC-18
Insurance........................................................................................................................................................SC-18
Transfer of rights ..........................................................................................................................................SC-18
ARC WELDING SUPPLIES - 07 847 7870

Hypertherm Powermax45 XP Specifications

General

Output Current	10-45 A
Gas Supply	Clean, dry, oil-free air or nitrogen
Torch Style	Handheld or mechanized
Input Voltage	50/60 Hz
Cutting Thickness	12 mm (1/2")
Cutting Capacity	16 mm (5/8 in)
Recommended Gas Inlet Flow Rate/Pressure	6.2 bar