INSTALL exec was invoked by the CMS user's profile with
a delay value of
100. When you restart the installation, you
should invoke the INSTALL exec with a larger delay value
(150
or
200).
If
the installation continues to fail, you should
continue to increase the delay value.
Prior to re-starting the
installation, you should erase any files created by the install
process
on
your remote system A-disk.
VMPCSERV installation places
15
files
on
your remote VM
system.
If
you have files there with the same names as those
VMPCSERV
is
trying to install, the installation will fail.
Before installing
VMPCSERVyou
must rename or erase any
files on your remote
VM
system that have these filenames
and
filetypes:
•
DISPAX TEXT
•
DISPIO TEXT
•
GENPCSER
EXEC
•
HEXIN
ASSEMBLE
•
HSTCMS TEXT
•
HSTCOM TEXT
•
HSTFSR TEXT
•
HSTGMEAC TEXT
HSTGMELN TEXT
HSTHYPE TEXT
HSTLOGO TEXT
•
HSTSPL TEXT
HSTVSI TEXT
•
VMPCSERV
EXEC
•
VMPCSERV
MODULE
If
the uploading of one
or
more text files in part 2 of the
install fails, but the
HEXIN
module has been created
successfully
on
your remote system, you can restart the
install process
by
issuing the command "PROFILE"
on
the
local session, and skip part 1
of
the install. You may also
load the text files in part 2
of
the install selectively if only 1
or
2 of the files was
not
loaded successfully. Before
restarting the installation, you should erase any
of
the text
files uploaded to your remote system which you will
be
trying to upload again.
Chapter 6. Remote Services
6-
7
To Next Page
Loading...
Need help?
General
