IBM Professional Series User Manual

Startup Failures
During the start up period, VMjPC can detect and report
the following types of failures:
STORAGE
ERROR, See VM j PC Users Guide RC =
2670
A storage error was detected, press the F 1 key to
attempt a retry.
If the retry is successful, the problem
may be intermittent. Record the numbered code (RC)
for reference and continue processing.
If the retry is unsuccessful, call your technical
coordinator
or run the diagnostics described in the
'Diagnostic Testing' section of the
PC XT j 370 Guide to
Operations.
• PROCESSING UNIT ERROR, See VMjPC Users Guide
RC = 2680
A processing unit error was detected, press the F 1 key to
attempt a retry. The recovery actions are the same as for
the STORAGE
ERROR described above.
• HARDWARE ERROR, See VMjPC Users Guide RC =
2681
An undetermined hardware error was detected, press the
Fl key to attempt a retry. The recovery actions are the
same as for the STORAGE
ERROR described above.
nnnnnnn File
Not Found, See VMjPC Users Guide RC
= 2695
A file that
is necessary to complete the start up process
could not be found. nnnnnnn
is the file name. It must be
reloaded from the distribution diskette. Notify your
technical coordinator
or refer to the procedures in
Chapter 2 (or Chapter 3 if you have recently
~
reconfigured your system).
nnnnnnn File Bad, See
VM j PC Users Guide RC = 2696
4-22 VMjPC Users Guide

IBM Professional Series Specifications

General

Brand	IBM
Model	Professional Series
Category	Software
Language	English