Message Explanations
Messages are listed alphabetically by their first word, except
for the first set of messages grouped under
"Replacement
Values."
These messages begin with a value that changes
based upon what you're doing
or
what your userid is, etc.
If
you receive a message
that
starts with your userid name, or
a command name you just issued, or a device number, check
the group of messages explained under the
"Replacement
Values"
heading.
REPLACEMENT
VALUES
command COMMAND
NOT
COMPLETED; REMOTE
SERVICES
NOT
AVAILABLE (DMK049E)
The command indicated could not be completed because
you have not started the Remote Services Program
(VMPCSERV).
'cuu mode' released (DMS726I)
The
specified disk has
been
released since you have
asked that another disk
be
accessed for
that
mode.
'cuu' already accessed as read/write 'mode' disk
(DMS059E)
You are trying to access the specified disk in read-only
mode,
but
you already have it accessed in
read/write
mode. You cannot have the disk accessed as a
read/write
disk and as a
read/only
disk. Release the disk with the
RELEASE
command
and
reissue the ACCESS
command.
'cuu' replaces 'mode (cuu)' (DMS724I)
The disk being accessed replaces the disk specified in
your search order. The disk it replaces
is
released.
cuu also
= 'mode'-disk (DMS725I)
The disk being accessed is also accessed as the 'mode'
disk.
Chapter 8.
VM/PC
Messages
8-3
To Next Page
Need help?
General
