If
you see the previous screen, the installation process has
failed. You will have to use the facilities provided by
DOS to
make sufficient space available. Before doing so, you should
read the section
on
"How
Much Disk Space Is
Required?"
After sufficient space
is
made available, read the section on
"Repeating the Installation Process." Then repeat the
installation process.
Note: You may see a value other than
1,600,000 appear on
your screen. This can happen because the Installation
Program calculates the storage required based
on
your needs.
Unable to Read Space Available on C Disk
If,
for some reason, the installation program was unable to
read how much free space
is
on your C disk, you will see:
IBM
V M / P C
INS
TAL
L A T
ION
PRO
C E D U
REM
E S
SAG
E
* * *
UNABLE
TO
READ
FREE
SPACE
ON
FIXED
DISK
* * *
The
installation
process
DID
NOT
COMPLETE.
After reading
this
message, press
ENTER.
If
you see the previous screen, the installation process has
failed. Before you can attempt
to
install
VMjPC
again, you
will have to make sure your C disk is properly prepared. The
list of items
to
check at the beginning of this chapter should
help, as should the
DOS CHKDSK command. When you are
satisfied that your C disk
is
ready, you should read the
section
on
"Repeating the Installation Process." Then repeat
the installation process.
VMjPC
Distribution Diskette
Not
Used
If
you are the first to install
VMjPC
on
your system, then all
six
of
the
VMjPC
Distribution Diskettes will be used
by
the
installation process.
If
you are the first
to
install
VMjPC
and
not
all six diskettes were used, then there
is
reason to
suspect something has gone wrong. In that case, you should
review the items listed
at
the beginning
of
this chapter.
If
Chapter 2. Installing
VMjPC
2-21
To Next Page
Loading...
Need help?
General
