IBM Professional Series User Manual

7. Commands - This chapter has two parts:
a. CP Commands - Contains explanations, formats,
and operand descriptions for
all VM/PC CP
commands.
b. CMS Commands - Contains explanations, formats,
and operand descriptions for all
VM/PC CMS
commands that are different from VM/SP Release 2
commands.
For those that are not different, only the
explanation and format are shown.
All users who want Reference Information about
commands used with
VM/PC should read this chapter.
8. Messages - This chapter contains all VM/PC messages,
and all
VM/PC CP messages with a brief indication of
what recovery action to take. The same information
is
provided for those VM/PC CMS messages an end user
is most likely to encounter. Users are referred to the
VM/SP System Messages book for any further
information. All users who want Information about
messages received from
VM/PC should read this
chapter.
9. Appendix A - CP/CMS Interface. All users who want
information about the internal operations of
VM/PC
should read this appendix.
10. Appendix B - 370 Processor Control. All users who
maintain the Control Program should read this appendix.
11. Appendix C - Comparison of
VM/SP and VM/PC -
This appendix should be read by experienced
VM/SP
users. It lists the functions found in VM/SP but not
found in
VM/PC and explains why they're not there.
12. Appendix D -
Operating Hints
13. Appendix E -
ASCII to EBCDIC Conversions
14. Appendix F - Distribution Diskette Contents
15 .. Glossary - All users should read this to find the meaning
of terms and acronyms used in this book.
Chapter 1. Introduction to VM/PC 1-5

IBM Professional Series Specifications

General

Brand	IBM
Model	Professional Series
Category	Software
Language	English