Caution: More than one user writing to the same virtual
device can result in permanent loss of data.
If
the mode
is
omitted, the default is R if the userid
is
for
another user.
If
you are linking to one
of
your own disks, the
default mode
is
the one defined in your configuration.
[PASS=]
password
is
the one to eight character string that must match
the access mode password for the dvcadrl specified
(this should not be confused with your user
password).
LOCAL
the LINK
is
to be resolved in the local system
configuration file.
REMOTE
the LINK
is
to
be resolved in the remote system
directory.
Usage Notes:
1.
If
you link
to
one of your own minidisks, the password
is
not required.
2.
If
REMOTE
is specified, the Remote Server must be
active for the link to be established.
3.
If
neither
LOCAL
nor
REMOTE
is
specified, the local
configuration file
is
searched.
If
the link
is
not resolved
locally
and
the Remote Server utility
is
active, the link
resolution will
be
attempted at the remote system.
Responses:
ENTER
READ
PASSWORD:
enter the read password to obtain read access.
ENTER
WRITE
PASSWORD:
enter the write password to obtain write access.
DEV
dvcadr2
LINKED
indicates
that
access has been established
to
the
requested minidisk. This response will not appear if
you have issued the
CP
SET IMSG
OFF
command.
Chapter 7.
VM/PC
Commands 7
-29
To Next Page
Loading...
Need help?
General
