NOTE:
The
VM/PC
installation process always uses only
one fixed disk (the C disk). You may have a system
with two fixed disks.
If
so, you can direct the
installation to your D disk prior to beginning the
installation process. To do this, issue the
DOS
command:
ASSIGN
C=D
Following installation, the ASSIGN command can be
used whenever you wish to use
VM/PC.
If
you
want to run
VM/PC
from your D disk without using
the ASSIGN command,
or
if you want
VM/PC
to
use
both
of your fixed disks, read Chapter
3,
"Configuring Your
VM/PC
System"
on
page 3-1.
Find out how much unused space
is
available on your C
disk. You can do this by using the
DOS commands
CHKDSK
or
DIR.
If
you do not have
at
least 1,600,000
bytes of available space, you should read the section
"How
Much Disk Space Is Required?" before
continuing.
Once you have satisfied the items to be checked, you are
ready to make your backup copy
of
the
VM/PC
Distribution
Diskettes.
Chapter 2. Installing
VM/PC
2-3
To Next Page
Loading...
Need help?
General
