NUCXLOAD
command
[fname
[ftype
[fmode]]]
[(options[)]]
options:
[SYstem]
[SErvice]
[Push]
Where:
command
is
the name
of
the command to be installed as a nucleus
extension.
fname
is
the filename
of
the module to be so installed.
If
this
item
is
omitted, it will be defaulted to "command."
ftype
is
the file type
of
the module to be so installed.
If
this
item
is
omitted, it will
be
defaulted to
"MODULE."
fmode
is the file type
of
the module to be so installed.
If
this
item
is
omitted, it will
be
defaulted to
"*."
options
may be any
of
the following (minimum abbreviation in
capitals):
SYstem
the program will be loaded in nucleus-type free
storage and will
not
be dropped if
an
abnormal end
occurs.
SErvice
the program will accept service calls.
Push
no check will be made for an existing nucleus
extension of the same name.
Return codes:
Chapter 7.
VM/PC
Commands 7
-103
To Next Page
Loading...
Need help?
General
