IBM Professional Series - Page 309

userid dvcadr NOT LINKED; VOLUME NOT MOUNTED
(DMK108E)
The device you entered was not linked because the
diskette drive that it was defined on did not have a
diskette in it or the drive does not exist.
userid NOT IN REMOTE DIRECTORY (DMK053E)
You entered a userid that could not be found in the VM
directory at the remote location.
Special Characters
?CP: command (DMK001E)
You did not enter a valid CP command.
B
BLKS MISSING OR INVALID (DMK024E)
You did not enter the number of blocks or entered it
incorrectly. It is incorrect if it is more than four
characters or is not a decimal number.
C
Cannot recompute without loss of data. No change
(DMS214W)
The number of blocks specified in the FORMAT
command cannot contain all the data on the disk. Erase
some files, or re-issue the FORMAT command with
more blocks specified.
CHARS MISSING OR INVALID (DMK245E)
You did not enter the CHARS operand or it is longer
than four characters.
CLASS MISSING OR INVALID (DMK028E)
You did not enter a class value or entered one that is not
in the range A through Z or 0 through 9.
8-6 VM/PC Users Guide