Error in fn
ft
fm, line nnn - message (DMS085E)
The
EXEC2
interpreter has found an error in the
specified file, at line
"nnn."
Correct the
EXEC
file based
on
the text
of
the error message, and re-issue the
command.
Error occurred when allocating a service (SERV)
You should retry
VMPCSERV
and contact your
technical co-ordinator if the program continues
to
fail.
Error occurred when trying setup/remove
I/O
interrupt
handler, return code: nnn (SERV)
You should retry
VMPCSERV
and contact your
technical co-ordinator if the program continues
to
fail.
Error occurred when trying to define a service (SERV)
You should retry
VMPCSERV
and contact your
technical co-ordinator if the program continues
to
fail.
ERROR
READING
CP
MESSAGE FILE (DMK016T)
The
control program
had
an
irrecoverable
data
error
while reading the control program message file. Restore
the message file from
VM/PC
installation diskette 2.
ERROR
READING
VM/PC
CONFIGURATION FILE
(DMK013T)
The
control program
had
an
irrecoverable
data
error
while reading the configuration file.
Run
the
configurator
to
correct any data problems.
Error when trying to display the logo (SERV)
You should retry
VMPCSERV
and contact your
technical co-ordinator if the program continues
to
fail.
Execution begins... (DMS7401)
You have requested the execution
of
a program
under
CMS.
Export terminated, insufficient disk space available
(DMS806E)
The
EXPORT
of
the file failed because there was no
space left
on
the drive
to
create the
PC
file. You should
make enough space available
on
the drive
to
create the
file, and retry the operation.
Chapter 8.
VM/PC
Messages
8-13
To Next Page
Loading...