IBM Professional Series - Page 321

Invalid parameter 'parameter' for 'function' function
(DMS026E)
The data specified for the given function is misspelled,
missing or invalid. Reissue the command with valid data
for the function.
Invalid parameter 'parameter' in the option 'option' field
(DMS029E)
The data entered following the specified option was
invalid. Reissue the command with valid data after the
option.
Invalid PC fileid 'd:filename.ext' specified (DMS804E)
The PC fileid specified is invalid. Retry the command
with a valid fileid.
INVALID PSW - psw (DMKOI2E)
The PSW (program status word) you entered in the
STORE command has the extended control mode bit on.
INVALID RANGE - range (DMK009E)
The range of addresses or registers you entered is
incorrect. For instance, the end address may be smaller
than the starting address.
INVALID REGISTER - register (DMKOI0E)
The register you entered was not in the range ° through
15 or hexadecimal ° through F, or was not 0, 2, 4, or 6
for a floating-point register.
INVALID SPOOLID - spoolid (DMK008E) .
The spoolid you entered was not a decimal number or
was longer than four characters.
Invalid subset command (DMS)
The command you entered cannot be executed from
CMS subset mode due to restrictions in where the
command must execute. Commands which execute in the
user area are not permitted to be executed from CMS
subset mode.
Invalid subsystem was specified on ALLOCATE (SERV)
You should retry VMPCSERV and contact your
technical co-ordinator if the program continues to fail.
8-18 VM/PC Users Guide