STORE
REGISTER EXCEEDS MAXIMUM VALUE
(DMK163E)
You entered more data to
be
consecutively stored in
either general
or
floating-point registers
than
there are
registers for
that
data.
T
TERMINAL ASYNCHRONOUS INTERRUPT WAS
NOT
ATTENTION (DMK002T)
An
asynchronous interrupt from the simulated 3277 for
the Local Session was presented and the status
associated with
that
interrupt was
not
attention.
The following names are undefined: (DMS201 W)
A list
of
names
of
unresolved external references
is
displayed. You may obtain access
to
the specified files
by
issuing the appropriate
INCLUDE
command,
or
ignore the warning message if the modules are
not
needed for correct execution
of
your program.
The remote server has been restarted. Connection
to
remote
disks has been lost. (DMS805E)
VM/PC
detected
that
the remote server has
been
stopped and restarted. You must re-establish the
connection
to
remote minidisks by issuing the
appropriate
LINK
and ACCESS commands for those
minidisks.
The remote server is not available. Connection to remote disks
has been lost. (DMS801E)
The
communication with the remote server program has
been
stopped. You must re-start the remote
VMPCSERV
program to re-establish communications
with the remote server, and issue the appropriate
LINK
and ACCESS commands
to
establish your remote
minidisks.
The
xx
disk does not exist. Disk
yyy
accessed as mode
z.
(SERV)
As the
VMPCSERV
program terminates and tries
to
restore the CMS environment which existed prior
to
your
using the remote server program, an error occurred as
Chapter 8.
VM/PC
Messages
8-23
To Next Page
Loading...