EasyManuals Logo

IDEC MICRO/I HG1P-ST32 Series User Manual

IDEC MICRO/I HG1P-ST32 Series
1665 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1066 background imageLoading...
Page #1066 background image
3 Preventive Maintenance Settings Dialog Box
17-10 WindO/I-NV4 User’s Manual
Data Type
Select the data type for the operation count device address as UBIN16(W) or UBIN32(D). For details, refer to
Chapter 2 “1.1 Available Data” on page 2-1.
Report when Operation Count has reached or exceeded Threshold level
Select this check box to report when the counted operation count reaches or exceeds the threshold.
(Data Type)
Selects the type of data for the threshold.
Level 1
Configures the level 1 threshold and Report Device Address.
Level 2
Select this check box to configure the level 2 threshold and Report Device Address.
Level 3
Select this check box to configure the level 3 threshold and Report Device Address.
Value: Uses a constant as the threshold.
Device Address: Uses a value of device address as the threshold.
Threshold Specifies the count as a constant or a device address that is the criterion for reporting at
level 1. For a constant, the range that can be set varies based on the data type. For a device
address, click to display the Tag Editor. For the device address configuration procedure,
refer to Chapter 2 “5.1 Device Address Settings” on page 2-68.
Report Device Address: Specifies the bit device or the bit number of the word device for reporting when the
operation count reaches or exceeds the level 1 threshold.
Click to display the Tag Editor. For the device address configuration procedure, refer to
Chapter 2 “5.1 Device Address Settings” on page 2-68.
Threshold Specifies the count as a constant or a device address that is the criterion for reporting at
level 2. For a constant, the range that can be set varies based on the data type. For a device
address, click to display the Tag Editor. For the device address configuration procedure,
refer to Chapter 2 “5.1 Device Address Settings” on page 2-68.
Report Device Address: Specifies the bit device or the bit number of the word device for reporting when the
operation count reaches or exceeds the level 2 threshold.
Click to display the Tag Editor. For the device address configuration procedure, refer to
Chapter 2 “5.1 Device Address Settings” on page 2-68.
Threshold Specifies the count as a constant or a device address that is the criterion for reporting at
level 3. For a constant, the range that can be set varies based on the data type. For a device
address, click to display the Tag Editor. For the device address configuration procedure,
refer to Chapter 2 “5.1 Device Address Settings” on page 2-68.
Report Device Address: Specifies the bit device or the bit number of the word device for reporting when the
operation count reaches or exceeds the level 3 threshold.
Click to display the Tag Editor. For the device address configuration procedure, refer to
Chapter 2 “5.1 Device Address Settings” on page 2-68.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the IDEC MICRO/I HG1P-ST32 Series and is the answer not in the manual?

IDEC MICRO/I HG1P-ST32 Series Specifications

General IconGeneral
BrandIDEC
ModelMICRO/I HG1P-ST32 Series
CategoryControl Panel
LanguageEnglish

Related product manuals