IDEC MICRO/I HG1P-ST32 Series User Manual

3 DM Link Communication
3-6 WindO/I-NV4 User’s Manual
3.2 DM Link Communication Settings
DM Link Communication settings are selected on the Select Communication Driver dialog box, or the
Communication Driver tab on the Project Settings dialog box.
• When creating new project data by following displayed dialog boxes and configuring settings step by step, by
clicking , and then clicking New, the Select Communication Driver dialog box is displayed. For details, refer
to Chapter 4 “Create new project data by using the interactive quick start” on page 4-1.
•Click Communication Driver on the status bar to display the Communication Driver tab on the Project
Settings dialog box. For details, refer to Chapter 4 “Changing Communication Drivers” on page 4-21.
Select IDEC System in Manufacturer, and then select DM Link (1:1), DM Link (1:N) or DM Link Ethernet
(UDP)
*1
in Communication Driver.
*1 HG5G/4G/3G/2G-V, HG4G/3G, HG2G-5F only

IDEC MICRO/I HG1P-ST32 Series Specifications

General

Brand	IDEC
Model	MICRO/I HG1P-ST32 Series
Category	Control Panel
Language	English