IDEC MICRO/I HG1P-ST32 Series User Manual

WindO/I-NV4 User’s Manual 10-47
2 Character Input
10
Data Displays
2.4 How to Enter Text
Use the keypad or key buttons to write character codes to device addresses with the Character Input. The input
methods are as follows.
■ Pressing the Character Input and Entering Text from the Standard Keypad
Arrange a Character Input on the screen and in its properties dialog box, on the General tab, under Keypad, select
Standard for Type.
External device
MICRO/I
HG SERIE
HG SERIES_
HG
HG_
HG SERIES_
HG SERIES
D100 :
4847
(Hex)
‘H’ ‘G’
D100 :
4847
(Hex)
‘H’ ‘G’
D100 :
D101 :
4847
(Hex)
‘H’ ‘G’
2053
(Hex)
4552
(Hex)
4945
(Hex)
5300
(Hex)
‘E’ ‘R’
D102 :
D103 :
D104 :
D100 :
D101 :
4847
(Hex)
‘H’ ‘G’
2053
(Hex)
4552
(Hex)
4945
(Hex)
5300
(Hex)
‘E’ ‘R’
D102 :
D103 :
D104 :
‘S’
(NULL)
‘ I ’ ‘E’
‘ ’ ‘S’
‘ I ’ ‘E’
‘S’
(NULL)
‘ ’ ‘S’
Press Character Input
Write text character
codes to device addresses
Press ENT
Display values of device addresses as text
(Entry mode)
Display values of device addresses as text
(Entry mode)
Close standard keypad
Display standard keypad
Enter text as
"HG SERIES"
Display values of device addresses as text
(Display mode)
Display values of device addresses as text
(Display mode)
When the following operations are performed, entry mode is canceled and the current values of device
addresses are displayed as character codes on the Character Input. To enter text, press the Character Input
again to select it and set it to entry mode.
• CAN was pressed
•When the Focus is moved by ENT button check box on the General tab is cleared and ENT was
pressed and a value was written to the device address

IDEC MICRO/I HG1P-ST32 Series Specifications

General

Brand	IDEC
Model	MICRO/I HG1P-ST32 Series
Category	Control Panel
Language	English