WindO/I-NV4 User’s Manual 8-3
1 Bit Button
8
Buttons
1.2 Bit Button Configuration Procedure
This section describes the configuration procedure for Bit Buttons.
1 On the Home tab, in the Parts group, click Buttons, and then click Bit Button.
2 Click a point on the edit screen where you wish to place the Bit Button.
3 Double-click the dropped Bit Button and a Properties dialog box will be displayed.
4 Change the settings on each tab as necessary.
The Trigger Condition tab and Options tab only appear in Advanced mode.
To Next Page
Loading...