Name: IDEC MICRO/I HG1P-ST32 Series
Brand: IDEC
Rating: 4 (1 reviews)

To Next Page

To Previous Page

4 Print Command

12-26 WindO/I-NV4 User’s Manual

4.2 Print Command Configuration Procedure

This section describes the configuration procedure for the Print Command.

1 On the Home tab, in the Parts group, click Commands, and then click Print Command.

2 Click a point on the edit screen where you wish to place the Print Command.

3 Double-click the dropped Print Command and a Properties dialog box will be displayed.

4 Change the settings on each tab as necessary.

Questions and Answers:

Need help?

Do you have a question about the IDEC MICRO/I HG1P-ST32 Series and is the answer not in the manual?

IDEC MICRO/I HG1P-ST32 Series Specifications

General