IDEC MICRO/I HG1P-ST32 Series User Manual

WindO/I-NV4 User’s Manual 14-1
14
Data Log Function
This chapter describes how to configure the Data Log function and its operation on the MICRO/I.
1.1 How the Data Log Function is Used
The Data Log function samples values of device addresses with the MICRO/I using the configured sampling condition
and Condition of Writing to Data Storage Area. The sampled values of device addresses are saved in internal memory
along with the sampling time.
The Data Log function can perform the following functions.
• Sample values of device addresses at a fixed interval
• Sample values of device addresses when a value of device address changes
• Output Data Log data to the external memory device
*1
*1 SD memory card for HG5G/4G/3G/2G-V, HG4G/3G and HG2G-5F, USB flash drive for HG2G-5T and HG1G/1P
Chapter 14 Data Log Function
1Overview
HG3G HG2G-5FHG5G-V HG4G-V HG3G-V HG2G-V HG2G-5T HG4G HG1G HG1P
MICRO/I
External device
D100 : 123
D100 : 55
12 : 00
12 : 05
12 : 10
D100 : 0
MICRO/I
External device
D100 : 123
0
1
Output to
External memory device
Data Log data (CSV)
MICRO/I
External Memory Device
USB flash drive
SD memory card

IDEC MICRO/I HG1P-ST32 Series Specifications

General

Brand	IDEC
Model	MICRO/I HG1P-ST32 Series
Category	Control Panel
Language	English