EasyManuals Logo

IDEC MICRO/I HG1P-ST32 Series User Manual

IDEC MICRO/I HG1P-ST32 Series
1665 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1069 background imageLoading...
Page #1069 background image
WindO/I-NV4 User’s Manual 17-13
4 Using the Data
17
Preventive Maintenance Function
12
On the General tab, under Display Type, click Decimal.
13
Under Data Format, in Data Type, select the data type for the value to display.
Select the same data type as the data type selected on the Operation Count tab in the Preventive Maintenance
settings Individual Settings dialog box.
14
Specify Digits for the value to display.
The digits that can be set varies based on the display type or data type.
15
Under Display Method, in Display Device Address, specify the destination device address for the counted
operation count.
Select the same device address as the device configured with Measure Operation Count on the Operation Count
tab in the Preventive Maintenance settings Individual Settings dialog box.
16
Click OK.
The properties dialog box closes.
This concludes the configuration to display the counted operation count on a Numerical Display.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the IDEC MICRO/I HG1P-ST32 Series and is the answer not in the manual?

IDEC MICRO/I HG1P-ST32 Series Specifications

General IconGeneral
BrandIDEC
ModelMICRO/I HG1P-ST32 Series
CategoryControl Panel
LanguageEnglish

Related product manuals