IDEC MICRO/I HG1P-ST32 Series - Page 1182

4 Operation
21-12 WindO/I-NV4 User’s Manual
• While a sound file is playing, the sound ID for the trigger device address that changed to 1 is put into a queue for
playback.
For example, when playing sound ID1 when trigger device address 1 is 1 and sound ID2 when trigger device
address 2 is 1, if trigger device address 2 changes to 1 while sound ID1 is playing, then sound ID2 playback starts
if trigger device address 2 is 1 when sound ID1 finishes playing.
However, if the trigger device address for sound ID2 is 0 when sound ID1 finishes playing, sound ID2 does not play.
• When the sound ID currently playing is set to Repeat: Enabled, no other sound IDs will play until the trigger
condition for this sound ID is no longer satisfied.
For example, when playing sound ID1 when trigger device address 1 is 1 and sound ID2 when trigger device
address 2 is 1, even if sound ID2’s trigger device address changes to 1 while sound ID1 is set to Repeat: Enabled
and repeatedly playing, sound ID1 playback continues. When sound ID1's trigger device address changes to 0,
sound ID2 playback starts if trigger device address 2 is 1.
Trigger Device Address 1
1
0
Trigger Device Address 2
1
0
Sound
Sound
Sound ID1
Sound ID2
Sound ID2
Trigger Device Address 1
1
0
Trigger Device Address 2
1
0
Sound
Sound
Sound ID1
Sound ID2 Sound ID2
Trigger Device Address 1
1
0
Trigger Device Address 2
1
0
Sound
Sound
Repeat: Enabled
Sound ID1
Sound ID1 Sound ID1
Sound ID2
Sound ID2