EasyManuals Logo

IDEC MICRO/I HG1P-ST32 Series User Manual

IDEC MICRO/I HG1P-ST32 Series
1665 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1212 background imageLoading...
Page #1212 background image
2 Security Function Configuration Procedure
23-12 WindO/I-NV4 User’s Manual
4 Specify the user number (1 to 15) in Number
This number is used when switching the user account via the value of device address.
5 Enter the name for the new user in User Name.
The maximum number for the user name is 8 characters. Only alphanumeric characters and symbols can be used.
6 Enter the password in New Password.
The number for the password is 4 to 15. Only uppercase alphabetic characters and numbers can be used.
7 Enter the password in Confirm Password that was entered in step 6.
8 Click the Group Membership tab.
Assign the security groups to the user being created.
Administrator, Operator, and Reader have already been provided in Security Group.
If you will not add a new security group, proceed to step
17
.
If you will not assign a security group, proceed to step
18
.
You cannot use the following characters in the user name.
\ / : * ? “ < > |
Write down the password so you do not forget it and save that note in a safe place.
To display the content of the password for New Password and Confirm Password, select the Show
Passwords check box in the Security dialog box.
User3User2User1
Administrator AdministratorOperator
Operator
Reader

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the IDEC MICRO/I HG1P-ST32 Series and is the answer not in the manual?

IDEC MICRO/I HG1P-ST32 Series Specifications

General IconGeneral
BrandIDEC
ModelMICRO/I HG1P-ST32 Series
CategoryControl Panel
LanguageEnglish

Related product manuals