WindO/I-NV4 User’s Manual 23-39
3 Security Dialog Box
23
User Accounts and the Security Function
New User Account Dialog Box and Change User Account Dialog Box
In the New User Account dialog box, the user name, password, and security groups are assigned to an account and
that user account is added.
In the Change User Account dialog box, the user name, password, and security groups for the selected user
account are changed.
General Tab
â– Number
In the New User Account dialog box, this setting specifies the number (1 to 15) when switching the account via the
value of device address.
When Edit was clicked and the Change User Account dialog box was displayed, this item displays the selected user
account number.
â– User Name
Enter the name for the user account.
The maximum number is 8 characters. Only alphanumeric characters and symbols can be used.
â– New Password
Enter the password.
The number of characters for the password is 4 to 15. Only uppercase alphabetic characters and numbers can be
used.
â– Confirm Password
Re-enter the same password.
You cannot use the following characters in the user name.
\ / : * ? “ < > |
Write down the password so you do not forget it and save that note in a safe place.
To display the content of the password for New Password and Confirm Password, select the Show
Passwords check box in the Security dialog box.
To Next Page
Loading...
Need help?
General
