WindO/I-NV4 User’s Manual 3-19
5 User Communication
3
Communication
29
Repeat steps
26
through
28
to specify all the data for the receive command.
30
Click OK.
The receive command configured in Command List and Data List on Project Settings dialog box is displayed.
To add a transmission command, repeat steps
8 through
19
. To add a receive command, repeat steps
20
through
29
.
• The data are displayed in Data List in the order they were set. To change the order of data, select data,
and then click Up or Down to shift it.
•Click Expand Data List to hide Type, Trigger Condition and Detail, the number of the data displayed
in Data List will increase.
To Next Page
Loading...