WindO/I-NV4 User’s Manual 28-21
2 FTP Server Function
28
Maintenance
● FTP Server Function Configuration Procedure
1 On the Configuration tab, in the System Setup group, click Project.
The Project Settings dialog box is displayed.
2 Configure the items on the FTP Server tab.
■ Enable FTP Server function
When the Enable FTP Server function check box is not selected, you cannot access the folder of the external
memory device inserted in the MICRO/I even when the connection from the FTP client to the IP address of the
MICRO/I has been established.(Default: Off)
■ Port Number
Specifies the port number to use for the FTP server function (0 to 65535). (Default: 21)
■ Connection Timeout
Set the timeout period. After you login MICRO/I, MICRO/I will keep monitoring for its traffic. If there is no traffic at all
for a specified period of time, the MICRO/I will disconnect the FTP client. (Default: 15 minutes)
■ Specify Target
Specify the folder and the external memory device inserted in the MICRO/I to be accessed from the FTP client. When
the Target is specified, you cannot access the level higher than the specified folder.
3 Click the OK button.
• The timeout period to login the MICRO/I is 1 minute.
•If Device Address is selected for (Data Type), note the following points:
- When the value of device address is 0, the Connection Timeout is 1 minute, and when the value of
device address is 61 or more, the Connection Timeout is regarded as 60 minutes.
- Once a network connection is established between the FTP client and the MICRO/I, the timeout period
cannot be changed. The timeout period needs to be set in Device Address before connecting the FTP
client to the MICRO/I.
When you access a file during its reading or writing operation, the reading or writing operation for the file
accessed is performed after the first processing is completed.
To Next Page
Loading...
Need help?
General
