IDEC MICRO/I HG1P-ST32 Series User Manual

WindO/I-NV4 User’s Manual 3-45
5 User Communication
3
Communication
Example: When Trigger Type in Trigger Condition is While ON, Device Address is LM100, Status Device
Address is LDR110, Completed Device Address is LM101 and the Not Clear Completed Device
Address automatically check box is not selected
When Status Device Address is LDR110, error information and time out information is stored in each
bit of LDR110.
When receiving of 1 frame of data is completed before the Receiving Time Out duration has elapsed
from when the trigger condition is satisfied, the value of the Receiving Time Out of the Status Device
Address LDR110 (address number+0, bit 14) remains 0.
When receiving of 1 frame of data could not be completed by the time the Receiving Time Out duration
elapses from when the trigger condition is satisfied, the value of the Receiving Time Out of the Status
Device Address LDR110 (address number+0, bit 14) changes to 1.
Comment：
Enter a comment for a command. The maximum number is 40 characters.
Receive command
Value of Device Address LM100 when
Trigger Condition is While ON
1
0
1
0
Value of Completed Device Address LM101
1
0
Receive data 1 frame
Receiving Time Out duration
Receive data 1 frame
Value of Receiving Time Out
(address number+0, bit 14)
of Status Device Address LDR110
1
0
0
1
0
1
Receive command
Value of Device Address LM100 when
Trigger Condition is While ON
Value of Completed Device Address LM101
Receive data 1 frame
Receiving Time Out duration
Value of Receiving Time Out
(address number+0, bit 14)
of Status Device Address LDR110
1
0
0
1
0
1
Receive command
Value of Device Address LM100 when
Trigger Condition is While ON
Value of Completed Device Address LM101
Receive data 1 frame
Receiving Time Out duration
Value of Receiving Time Out
(address number+0, bit 14)
of Status Device Address LDR110

IDEC MICRO/I HG1P-ST32 Series Specifications

General

Brand	IDEC
Model	MICRO/I HG1P-ST32 Series
Category	Control Panel
Language	English