IDEC MICRO/I HG1P-ST32 Series - Page 174

5 User Communication
3-68 WindO/I-NV4 User’s Manual
Example 8
When the trigger condition is satisfied, the received data is stored in device addresses in the following order.
Data from the beginning of the received data to Constant (Hexadecimal) data is stored in the device address.
Constant (Hexadecimal) data is not stored.
Example 9
When the trigger condition is satisfied, the received data is stored in device addresses in the following order.
When the LDR200 value is 2
Item Setting
Conversion Type ASCII to Decimal
Device Address LDR100
Use Reference Device Address OFF
Number of bytes 2
Words 3
Variable ON
Item Setting
Conversion Type No conversion
Device Address LDR100
Use Reference Device Address ON, Device Address: LDR200
Storage Method of data from Upper byte
Words 2
Variable OFF
LDR100:
LDR101:
LDR102:
2
(32h)
Value of Device Address
1
(31h)
3
(33h)
NUL
(00h)
1
(31h)
2
(32h)
3
(33h)
ETX
(03h)
Words: 3
12
3
(DEC)
(DEC)
0
ASCII to Decimal
(DEC)
2 bytes
Received data
Constant (Hexadecimal) dataStored data
Order of reception
Constant (Character) data
0 is stored.
The stored data is smaller than the
size specified for Words.
Insufficient by 1 word
0 is stored.
0000hLDR100:
0000hLDR101:
3132hLDR102:
3334hLDR103:
No conversion
1
(31h)
Upper Lower
Value of Device Address
2
(32h)
3
(33h)
4
(34h)
Received data
1
(31h)
2
(32h)
3
(33h)
4
(34h)
Order of reception
LDR200=2
Words: 2
Bytes: 2