IDS IDS-iSYS User Manual

5-2-1- General Maintenance
5-2-1-1- Cleaning the reagent compartment and Plexiglas
®
!
Do not use any spray products on the analyser.
•
Open the reagent compartment drawer.
•
Clean the upper lid with absorbent paper soaked in de-ionised water.
•
Clean the compartment base plate with absorbent paper soaked in de-ionised water. Then use a disinfectant
wipe/solution suitable for medical devices.
•
Close the drawer.
•
Open the lid and insert the lid support tool (see pages 35 and 36).
•
Clean the Plexiglas
®
over the reagent compartment with absorbent paper soaked in de-ionised water. Then
use a disinfectant wipe/solution suitable for medical devices.
•
Remove the lid support tool and close the lid (see page 36).
•
When maintenance is complete, click on the corresponding , then confirm the
maintenance by clicking on YES.
5-2-1-2- Cleaning the sample tray and Plexiglas
®
WARNING:
RISK OF BIOLOGICAL CONTAMINATION
This part of the analyser is in contact with biological samples. There is, therefore, a
potential risk of infection.
Wear disposable gloves for all handling procedures.
!
Do not use any spray products on the analyser.
•
Open the sample drawer.
•
Clean the surface of the fixed or removable tray with a disinfectant wipe/solution suitable for medical
devices.
WARNING:
RISK OF INJURY
If a position of the fixed tray has to be cleaned, take care not to push the wipe into
the position with your finger.
Risk of cuts from the detection sensors.
Maintenance
5-2- Weekly Maintenance (continued)
IDS-iSYS User Manual - Revision M1!
Maintenance 5-2
119
Software version V 14

IDS IDS-iSYS Specifications

General

Brand	IDS
Model	IDS-iSYS
Category	Measuring Instruments
Language	English