3-10- Results
As the run cycle progresses, the status of the sample tray position changes when all the tests associated with
this position have been completed.
The colour code associated with the output of results is as follows:
Calibrators / Controls / Samples: assays in process.
Calibrator: all calibrations are correct.
Control: all results are within the limits defined.
Samples: results calculated without any message.
Calibrators: Calibrations are completed but one of the parameters is not
within the criteria set for automatic validation.
Controls: all results are calculated but at least one of the results is outside
the limits defined.
Samples: all results are calculated but at least one of the results has an
attention message.
Calibrators / Controls / Samples: a lack of reagent/sample or another fault
prevents the requested assays being carried out in full.
Only when assays are stopped.
Calibrators / Controls / Samples: incomplete processing of another
workload. The assays programmed for this position were not completed
due to a problem encountered before the end of the assays.
Samples: the results are stored in accordance with the criteria defined for
automatic filing and received by a centralised computer system (if the
connection is activated).
Only when the connection with a centralised computer system is
activated.
Samples: the profile is completed but the results have not been
sent/received by a centralised computer system.
IDS-iSYS User Manual - Revision M1!
Use 3-10
80
Software version V 14
To Next Page
Loading...
Need help?
General