Infors Multitron - Page 145

Multitron - Incubation Shaker
Index
25 February 2019 Page 143 of 146
direct steam humidification ......................... 117
general faults ...................................... 111, 114
shaker drive ................................................ 115
tempering .................................................... 116
Fernbach flasks, requirements ......................... 10
Flasks ............................................................... 10
Floor heating ..................................................... 38
Frame
base, 13 cm .................................................. 31
base, 41 cm .................................................. 32
Functional description
analogue output ............................................ 46
CO
2
control .................................................... 41
cooling ........................................................... 34
direct steam humidification ........................... 38
external cooling ............................................. 36
interior lighting ............................................... 31
tempering ...................................................... 27
Fuses
position .......................................................... 17
replace ........................................................ 118
G
Guidelines ........................................................... 8
H
Heating ........................................................... 134
Height above sea level ................................... 107
High .......................................................... 83, 109
Holders
fit ................................................................... 73
overview ........................................................ 59
screw sizes ................................................... 74
Hose pass-through
position .......................................................... 47
use ................................................................ 48
Humidification ................................................... 38
Humidity sensor
position .......................................................... 38
specification ................................................ 138
I
Identification of the equipment ......................... 33
Identification of the throw .................................. 33
Identification plate
position .......................................................... 33
Installation ......................................................... 65
Installation location ........................................... 65
Intended use ...................................................... 9
Interior dimensions ......................................... 129
Interior lighting
configure ...................................................... 106
functional description .................................... 31
specification ................................................ 131
Intermediate base ............................................. 44
Internal cooling
specification ................................................ 134
Interrupted power supply ................................ 108
K
Key tone
activate/deactivate ...................................... 105
L
LED lighting
operate .......................................................... 45
specification ................................................ 139
Lighting
configure ...................................................... 106
functional description .................................... 31
specification ................................................ 131
Load .................................................................. 75
Low .......................................................... 83, 109
M
M tray ................................................................ 49
Main switch ....................................................... 32
Mains connection .............................................. 28
requirements ................................................. 66
Maintenance ................................................... 119
Maintenance schedule .................................... 119
Materials ......................................................... 131
Maximum rotation speed
with microtitre box ......................................... 62
with Sticky Stuff ............................................. 58
Measurements ................................................ 129
Messages
ALARM ................................................. 79, 109
bLoc ...................................................... 83, 110