Multitron - Incubation Shaker
Safety and Responsibility
25 February 2019 Page 19 of 146
2.10 Declaration of Decontamination
When returning the equipment for repair, disassembly or disposal,
it is required for the safety of all parties involved and because of
legal provisions that a lawful declaration of decontamination is pre-
sent.
The following must be observed if this is the case:
The equipment, the component part or accessory must be en-
tirely decontaminated before sending to the manufacturer
The provider is therefore required to completely and truthfully
fill out a declaration of decontamination, and have it signed by
the person responsible.
The declaration of decontamination must be affixed on
the outer packaging in which the equipment is sent back.
These forms can be obtained from the licensed dealer or the
manufacturer. See address on page 2.
Important notice
If the return shipment is not accompanied by a signed and com-
plete declaration of decontamination or it is not affixed to the outer
packaging, the shipment will be returned unopened to the sender
at their expense (see also T&C).
To Next Page
Loading...