Multitron - Incubation Shaker
Options
Page 46 of 146 25 February 2019
4.6.3 Specifications and Technical Data
For a detailed description of the technical data and possible set-
tings, see chapter 12.4.6 "LED Lighting", page 139.
4.7 Darkening
The glass panel of the door can be covered with white adhesive
film on the inside. This is used for darkening as well as to ensure
better light distribution in the incubation chamber when using LED
lighting.
4.8 Analogue Output
4.8.1 Setup and Function
The equipment can optionally be equipped with an analogue output
module. This provides 8 channels via which setpoints and actual
values can be transferred to external equipment.
The output module is located at the back of the equipment in its
own casing. The signal range corresponds to 4 up to 20 mA with a
precision of ± 0.05 mA.
The operator must pre-assemble and connect the cable. To con-
nect the cable, the lid of the casing can be removed by loosening
the four hexalobular screws (M4x6). The cable is guided out of the
casing using a cable gland. This protects the cable as well as the
output module from mechanical influences and humidity.
To Next Page
Loading...