Infors Multitron - Programming the Timer - Single Change

Multitron - Incubation Shaker
Operation
25 February 2019 Page 91 of 146
7.5.2 Programming the Timer - Single Change
Programming the timer for a single change consists of the following
steps:
a) Entering the time for the first phase.
b) Entering the setpoint values for the first phase and switching
on the parameters.
c) Making sure that the timer for the second phase (Time 2) is
switched off.
d) Entering the setpoint values for the second phase and
switching on the parameters.
e) Starting the timer.
Entering the time for the first phase
Procedure 1. Tap the TIMER key to start the timer function.
On the upper alphanumeric display the sign Time 1 and the
message OFF appear. Additionally the sign Timer is lit up.
INFORMATION
Possibly the message OFF for the second timer (Time 2) ap-
pears on the lower alphanumeric display. Then the TIMER key
needs to be tapped again to get to the first timer (Time 1).
2. To set the time, tap the SET key in the upper setting key area.
The sign Setpoint indicates, that the time can be entered.
3. Use the Plus or the Minus key in the upper setting key area
to set the time for the first phase (Time 1).
The time set is shown either in hours (
h
) and minutes (
min
) or
in days (days) and hours (h).