Multitron - Incubation Shaker
Operation
Page 84 of 146 25 February 2019
7.4.2 Setting the Parameter Setpoints
To set the parameter setpoints, proceed as follows:
Procedure 1. Select the desired pair of parameters with the Select key (1).
The alphanumeric display field shows the current values of the
selected parameter pair.
2. To activate programming, tap the SET key (2) in the upper or
the lower setting key area, depending on which parameter set-
point should be set.
The alphanumeric display field shows last set setpoint of the
parameter. The Setpoint sign indicates, that the parameter
setpoint can be set.
The Setpoint sign lights up for 10 seconds. If you do not make
an entry in that time, you have to tap the SET key again.
3. Use the Plus or Minus key (3) to set the desired setpoint of
the selected parameter.
After approx. 10 seconds the Setpoint sign disappears and the
new setpoint is saved. You can speed up this process by tap-
ping the Select key.
The entered value is saved automatically. A separate confirma-
tion is not necessary. If the parameter is already activated, the
changes take effect immediately.
1
2
3
To Next Page
Loading...