Infors Multitron - Markings on the Equipment; Identification Plate; Identification of the Throw

Multitron - Incubation Shaker
Setup and Function
25 February 2019 Page 33 of 146
3.8 Markings on the Equipment
3.8.1 Identification Plate
The identification plates for identifying the equipment are located
on the
right side of the casing, directly above the mains connection
and on the front of the door.
For information on the data provided on the identification plate see
chapter 1.3 "Equipment Identification (Standard Identification
Plate)", page 8.
3.8.2 Identification of the Throw
At the back wall inside the incubation chamber, there is a sticker
that identifies the throw of the equipment.