Infors Multitron - Turning a Parameter on or off

Multitron - Incubation Shaker
Operation
25 February 2019 Page 85 of 146
7.4.3 Turning a Parameter On or Off
Turning a parameter on
To turn a parameter on, proceed as follows:
INFORMATION
Steps 1 and 2 can be omitted, if the parameter is turned on di-
rectly after entering the setpoint value.
Procedure 1. Select the desired pair of parameters with the Select key (1).
The message OFF indicates, that the parameter is switched
off.
2. Tap the SET key (2) in the upper or the lower setting key area,
depending on which parameter should be switched on.
On the alphanumeric display the setpoint value of the parame-
ter is shown. The sign Setpoint indicates, that the parameter
can be switched on.
3. To switch on the parameter, tap the ON/OFF key (3) in the
according operating key area.
The parameter is instantly turned on.
The sign Setpoint disappears. On the alphanumeric display
the message on appears for a very short time, then the cur-
rent value of the parameter is shown.
INFORMATION
When the parameter rotation speed (RPM) is activated, the
shaker table starts to move instantly. It is therefore suggested to
turn it on last.
1
2
3