Multitron - Incubation Shaker
Operation
Page 86 of 146 25 February 2019
It takes a while for the parameters to reach the entered setpoint
value. The sign High or Low lights up, if the current value of a
parameter is above respectively below its setpoint value.
Turning a parameter off
Turning off a parameter is carried out the same way as switching
on a parameter. The desired parameter can be selected by tapping
the Select key and afterwards switched off by tapping the ON/OFF
key. Is the parameter switched off, the message OFF appears on
the alphanumeric display.
7.5 Timer Function
If cultivation is started at low temperatures and the temperature
is then increased (e.g. when using the timer), condensation can
form on the flasks because these are heated up slower than the
ambient air. In conjunction with the «Sticky Stuff» adhesive mat-
ting, this can lead to the flasks coming off the adhesive matting.
7.5.1 Overview
The timer function allows you to programme defined sequences
(e.g. changing parameter setpoints after a defined time period or
delaying the start of the cultivation process). The timer can be pro-
grammed in two different modes:
One-time change from phase 1 to phase 2
Cyclical change between phase 1 and phase 2
More complex sequences and procedures (e.g. daylight curves)
can be realised with the bioprocess platform software eve
®
To Next Page
Loading...